High and low temperature universal creep testing machine

Product Introduction:

High and low temperature universal creep testing machine is mainly used for non-metallic materials creep, stress relaxation, tensile, compression, bending, shearing, stripping, tearing and other tests.

Applicable standards:

GB/T 11546.1-2008 Determination of the creep properties of plastics - Part 1: tensile creep

GB/T 15048-94 Test method for compressive creep of rigid foam plastics

GB/T 20672-2006 Determination of compressive creep of rigid foam under specified load and temperature conditions

GB/T 104.1-2006 - Determination of tensile properties of plastics - Part 1

GB/T 1041-92 Test method for compression properties of plastics

GB/T 9341-00 Test method for bending properties of plastics

Main indicators:

1. Test force:

- Maximum test force （kN） : 10

- Effective force measurement range: 0.4%-100%FS（internal and external ungraded）

- Resolution: 1/300000

- Relative error: ±0.5%

2. Test speed:

- Speed adjustment range: 0.05 —— 500mm/min（stepless speed regulation）

- Speed relative error: ±0.5%

- Control range of uniform test force rate and uniform deformation rate: 0.01% —— 5%FS/S

- Uniform test force rate, uniform deformation rate control error: ±0.5%

- Constant test force, constant deformation control range: 0.5% —— 100%FS

- Constant test force, constant deformation control error: less than 10%FS is ±1% of the set value, greater than 10%FS is ±0.1% of the set value

3. Displacement （moving the beam）

- Measuring range: 0 —— 999mm

- Resolution: 0.001mm

- Relative error: ±0.5%

Step 4 Transform

- Beam deformation measurement accuracy: ±0.5%

- Deformation measurement range in beam test: 860mm

- Large deformation measurement accuracy: ±0.5%

- Large shape measurement range: 25-1000mm

5. Host and accessories

- Maximum test force kN 10KN

- Effective test width mm: 420

- Maximum travel of moving beam mm: 1160

- Overall dimensions （length × width × height）mm: 900×480×1810

- Maximum clamping force of wedge chuck （kN） : 10

Clamping range: plate mm: 0-8, rod mmφ : 6-φ16, compression device mm: φ70, bending device: support roll radius MMR2.5-R5.0

- Roller diameter mm: φ5

- Offset range mm: 120